#CUDO MINER RASPBERRY PI SOFTWARE#
#CUDO MINER RASPBERRY PI DOWNLOAD#

Save the file and safely remove the USB flash device. Note that this is different from the user account username you use when logging into the web console. If you are unsure of this value, you can look in the Cudo Miner web console, where you will find it under organization settings. Within the double-quotes, provide your Cudo Miner organization username. Under the section ‘ seed‘ → ‘ miner‘, you will find the entry ‘org’. This pre-seed configuration is a JSON file, so use caution not to break the formatting.

In here, you will find a single file called ‘ seedconf.txt‘. Note that other partitions will be shown for the device, that are not accessible from within Windows, which you should ignore for this step. If you would like to do this, navigate to the partition called ‘ cudoosseed‘ on the newly-written USB flash device.

However, you may optionally choose to pre-configure the setting that enrols the worker to your organization in Cudo Miner. You do not need to do anything further, prior to using the USB flash device. A progress bar is shown for each stage.ĥ – Optional: Pre-configure the worker enrolment The write speed of the device will also affect the time taken.

#CUDO MINER RASPBERRY PI DOWNLOAD#

The compressed download is approximately 1.1GiB in size, which will be automatically decompressed by balenaEtcher, prior to writing to the device. The time needed to complete the flashing process will vary. Be careful to check you have selected the correct device, as any existing data will be irrecoverably destroyed when it is flashed. When you have selected both the image and target, you can start the USB flashing process. Low quality or slow USB flash devices may result in a sub-optimal experience.Ĭonnect the target USB flash device to your computer and proceed to select it in balenaEtcher. We recommend using a Hi-Speed USB 3.0 or better flash device, of size 8GB or greater, for running CudoOS. Otherwise choose the ‘ Flash from URL‘ option and enter the address from above. If you downloaded the image ahead of time, in balenaEtcher choose the ‘ Flash from file‘ option and navigate to the downloaded file. You should use to source the download, to make sure you’re getting the official software. Alternatively, you may choose to download it ahead of time.

#CUDO MINER RASPBERRY PI SOFTWARE#

The balenaEtcher software allows you to specify the URL for the CudoOS image in the software directly. We recommend downloading balenaEtcher from their site at to do this. You will need software to flash the CudoOS image onto a USB stick. 1 – CudoOS image and USB flashing software

Cudo miner raspberry pi